Scott Genius MC20 Carbon frame with alloy rear stay mounting: Broken rear stay mount. Normally this is a throw away frame because the cracked alloy part is too close to the carbon frame. Epoxy and heat don’t mix. I welded the alloy mount at the same time protecting the carbon frame. In fact I increased the area of support as this is a known problem on this model.
Posts
Got this Cube Litening that had a side impact. The seat stay was broken off at the top and bottom of the chain stay. The seat stay piece was also snapped into two pieces. The first job was to align the broken parts together with a strong epoxy on the frame itself. Once cured in perfect alignment the repair could begin. Each break was rebuilt with 5 layups of different CF weave to ensure stiffness. In this case I resprayed the repair.
Another sad but all too typical worn brake tracks on perfectly good wheels. It’s a time consuming job to ensure the re-build is flush, level and can withstand high heat and abrasion. Don’t ask what I use…it’s not off-the-shelf epoxy.
I was sent a set of Bontrager 700’s that had melted down an Alpine run. The rear wheel profile was deformed from the incorrect pads and brake surface was de-laminated. Luckily the wheel was still true so I took on the project.
Firstly the profile had to be reset by creating a mold of the correct profile. After cutting away the damaged area I rebuilt the wheel and brake surface. It is important to get the weight the same so there is no bias to a heaver side. The wheels are as good as new.
Bianchi Infinito. Down tube was damaged. 8 x uni and bi carbon fibre layup. Frame still weighs as per original